Mon–Fri 09:00–23:00 (Italy time) +1 800 470-1082 [email protected]
IT

Buying guides

Writing a material specification.

Buyers and inspectors rely on recognized standards so that a grade means the same thing in a mill certificate and in a contract. This page is a short field guide, not a substitute for the standard itself.

When you already know the designation, quote it exactly (including year or amendment if your contract requires it). When you do not, describe the use, mechanical or chemical limits you must meet, and the form, and ask for a suggested designation in the quotation.

How designations are usually written

A complete call-out typically has a standards body, a document number, a grade or type, and the product form.

  • ASTM A36 for carbon structural steel plate
  • EN 10025-2 grade S355 for structural steels
  • ASTM A240 / EN 10088 for many stainless sheet and plate grades such as 304/304L and 316/316L
  • ASTM B152 for copper sheet, strip, plate and rolled bar

Always confirm the current edition in your own quality system; this website does not replace the published standard.

Form (typical)Examples of references buyers often citeWhat to add in an inquiry
Structural steel plate or sectionEN 10025 (e.g. S235, S355); ASTM A36; ASTM A516 for some pressure-vessel plateThickness, width, length, impact-test temperature if required, surface condition
Stainless sheet, coil or plateASTM A240; EN 10088; grades such as 304/304L, 316/316LFinish, thickness, edge, coil ID/OD or plate size, any corrosion or polish requirement
Copper sheet, strip, tube or rodASTM B152 (sheet/strip/plate); other ASTM B or EN copper product standards by formTemper, thickness or diameter, cleanliness, electrical or thermal duty if relevant
Engineering plastics (general)ISO product designations (for example ISO 1874 for many polyamides) plus a data sheetResin family, colour, fire or food-contact requirement if any, form (sheet, rod, resin)

The table is illustrative of how specifications are commonly written. It is not a catalogue of items in stock and not a claim that every grade is available on demand.

Certificates and tests

Mill test certificates, inspection certificates issued to EN 10204 types when that system is used, and third-party inspection are separate choices. If you need a particular certificate type or an independent inspector, say so in the inquiry rather than assuming it is included.

Drawings and tolerances

For cut-to-measure or manufactured parts, put tolerances on the drawing (or cite a general tolerance standard you use). See also how to request a quote and the metals and product design pages.